For a smaller the better plastic part design, the ten measured part thicknesses are: 0.3mm, 0.32mm, 0.4mm, 0.41mm, 0.22mm, 0.38mm, 0.29mm, 0.27mm, 0.33mm, and 0.50mm. a) if the average loss at 0.33 is $12.40, what is the loss function? b) what is the loss at 0.5mm? c) what is the average loss if the target value is 0.40mm and the coefficient is 8200?

the answer is c i did the same question so i know that's right!

explanation:

newton's third law, for every action there is an equal and opposite reaction.

both the fifth and fourteenth amendments of the united states contain a due process clause. while the fifth amendment describes a legal obligation of the federal government to not deprived of life, liberty or property without due process of law, the fourteenth amendment applies the same obligation to the states to guarantee that all of the states provide fair procedures as well.