Ametal bar with a rectangular cross section of height, h, and width, w, is fastened to a rigid wall with three pins. the pins will fail in shear at a stress level of τ fail. assuming that there is a gap, s, between the edge of the pin holes and the edge of the pins and that the pins are fixed to the wall, determine the change in temperature required to bring the end pins to the point of failure (assume direct shear failure). s = 2.5 mm h = 60 mm w = 45 mm diam_pin = 20 mm τ fail = 110 mpa l = 1.4 m α_bar = 17x10^-6/deg c e_bar = 200 gpa

What elements are found in the inner and out core of the earth? the correct layers of earth's interior from the top to the center? what is the unwanted material that is removed from a mine called? how much stronger is an earthquake that registers 5 on the richter as opposed to 2? what occurs at a convergence plate boundary? the majority of the the earth's rock what is the most common element found in the earth's crust? what element is found in pyrite that contributes to acid mine drainage? why must mining companies post bond prior to permitting? how are bacteria being used in treating effluent from mines? what is a problem of acid mine drainage in rivers and soils? what do tectonic plates move on? why is gold smelting so damaging? how are artesian wells formed? where is dammed water colder than the river it flows into? what is one of the problems of uncontained aqueducts? what is the largest use of industrial water? underground sand and gravel formations that can store water? what type of water test measure acidity? which type of water test for cloudiness from suspended solids? what water test measures the amount of calcium and magnesium? these are all problems of coal power plants all of the following are advantages of riparian lands along rivers what type of water would be the warmest and have the least amount of dissolved oxygen? the zone of aeration is

The coefficient of friction is a number that represents the resistance to sliding between two in contact with one another.

What are the north and south poles of a solenoid change with?