Tom d. spends his spare time running a bungee jumping service off the henley street bridge. he has a 153 ft long bungee cord (unstretched) that has a spring stiffness of 22 lb/ft. to test his bungee, he ties the bungee cord to the bridge railing, ties the other end to an unnamed person weighing 135 pounds, and then gently nudges the person off of the bridge. determine the professor's speed when the bungee cord starts to stretch.

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

Acommercial refrigerator with refrigerant-134a as the working fluid is used to keep the refrigerated space at -35°c by rejecting waste heat to cooling water that enters the condenser at 18°c at a rate of 0.25 kg/s and leaves at 26°c. the refrigerant enters the condenser at 1.2 mpa and 50°c. if the compressor consumes 3.3 kw of power, determine (a) the mass flow rate of the refrigerant, (b) the refrigeration load, (c) the cop, and (d) the minimum power input to the compressor for the same refrigeration load.

The temperature in gavin's oven is a sinusoidal function of time. gavin sets his oven so that it has a maximum temperature of 280°f and a minimum temperature of 240°. once the temperature hits 280°, it takes 20 minutes before it is 280° again. gavin's cake needs to be in the oven for 30 minutes at temperatures at or above 270°. he puts the cake into the oven when it is at 260° and rising. how long will gavin need to leave the cake in the oven? (round your answer to the nearest minute.)