Physics, 23.10.2019 18:50, kprincess16r
You work in a machine design department and need to specify the diameter of a pin that slides back and forth through a hole. the hole diameter is specified as 0.500 inch with a tolerance of ±0.010 inch. the maximum pin diameter must be 0.002 inch smaller than the minimum hole diameter. if the pin diameter has a tolerance of ±0.010 inch, what diameter, in inches, should you specify for the pin?
Answers: 2
Physics, 21.06.2019 18:30, Rusven
An experiment is designed to test the relationship between the initial height of a basketball before it is dropped to the height of its rebound bounce. the height of the rebound bounce is measured using a scale positioned behind the ball. in the above experiment, which condition would not be controlled? a). the starting height of the ballb). the surface the ball bounces on c). the type of ball d). the method to measure the rebound height of the ball
Answers: 1
Physics, 21.06.2019 19:30, jonquil201
The us government wants to allocate billions of dollars in the next 10 years to assure our future energy security. the funds will be spread among a variety of possible energy resources. where do you think the government should put the greatest support: solar energy, wind energy, clean coal, oil exploration, gas exploration, or a combination of sources? are there other efforts that should be explored? support your position with cited information for both questions.
Answers: 2
Physics, 21.06.2019 20:40, nicollexo21
The metric unit of electrical power is the watt volt ampere ohm
Answers: 1
You work in a machine design department and need to specify the diameter of a pin that slides back a...
Mathematics, 11.09.2019 23:10
Mathematics, 11.09.2019 23:10
Advanced Placement (AP), 11.09.2019 23:10
Mathematics, 11.09.2019 23:10
English, 11.09.2019 23:10