Aplace kicker kicks a football at an angle of 42 degrees above the ground with a speed of 22 m/s. a) find time to max. height? b) find time to the ground? c) find max. height of the ball? d) find the horizontal displacement of the kickoff?

A) The time to the maximum height is 1.50 seconds

B) The time to the ground is 3.0 seconds

C) The maximum height is 11.06 meters

D) The horizontal displacement of the kickoff

Explanation:

A place kicker kicks a football at an angle of 42 degrees above the

ground with a speed of 22 m/s

→ u = 22 m/s and Ф = 42°

where u is the initial velocity and Ф is its direction

At first lets find the initial components of velocity

The initial horizontal component is u cosФ

→ The initial horizontal component is 22 cos(42)

The initial vertical component is u sinФ

→ The initial vertical component is 22 sin(42)

A)

At the maximum height the vertical component of velocity is zero

The vertical component of velocity after t seconds is

→ = u sinФ + g t

Where g is the acceleration of gravity and t is the time

→ g = -9.8 m/s² , = 0

→ 0 = 22 sin(42) - 9.8 t

Add 9.8 t for both sides

→ 9.8 t = 22 sin(42)

Divide both sides by 9.8

→ t = 1.50 seconds

The time to the maximum height is 1.50 seconds

B)

At the ground the vertical displacement y = 0

So The ball will fall from the maximum height again

Then it will take the same time for the maximum height

The time of the flight of the ball from the ground to the ground again is

double the time from the ground to the maximum height

→ The time to the maximum height is 1.50 seconds

→ The time to the ground = 2 × 1.50 = 3.0 seconds

The time to the ground is 3.0 seconds

C)

The maximum height of the ball is the vertical component of the displacement y

→ y = u sinФ t + g t²

The time for the maximum height is 1.50 seconds

→ g = -9.8 m/s² , u sinФ = 22 sin(42) , t = 1.5

- Substitute these values in the rule above

→ y = 22 sin(42)(1.5) - 4.9(1.5)²

→ y = 22.08 - 11.025

→ y = 11.06 m

The maximum height is 11.06 meters

D)

The horizontal displacement x is the product of the initial horizontal

component of the velocity and the time of the flight of the ball

→ x = (u cosФ) t

→ The initial horizontal component of velocity is 22 cos(42)

→ The time of the flight of the ball is 3 seconds

Substitute these values in the rule above

→ x = 22 cos(42) × 3

→ x = 49.05 m

The horizontal displacement of the kickoff is 49.05 meters

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

you go to your settings preference and in the end youll see sth that says "i want to delete my acc" click on it and u'll acc will be deleted but u have to wait.