Physics, 02.10.2019 05:00, lyndamahe0

For the following sections assume concrete of compressive strength of 6,000 psi and reinforcing steel bars with yield strength of 60 ksi to calculate a. the moment of inertia of the uncracked transformed section b. the cracking moment c. the stresses in the steel and concrete right after cracking d. the stresses in the steel and concrete when the moment is 40% of the cracking moment e. the stresses in the steel and concrete when the moment is 140% of the cracking moment f. would the cracking moment be the same for positive and negative moments? justify your answer for each beam.

Answers: 3

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 01:40, sasalinas2001

In all trials, the magnitude of the final velocity for g1 + g2 was less than the magnitude of any initial velocity. as mass increased, what happened to the velocity? the velocity decreased. the velocity increased. the velocity of g1 + g2 could not be measured. the velocity was not affected by the mass increase.

Answers: 1

continue

Physics, 22.06.2019 10:30, Fire8615

In automobile steering wheel is shown what is the ideal mechanical advantage blank? if the ama is eight what is the efficiency of the steering wheel?

Answers: 1

continue

Physics, 22.06.2019 13:40, youngbeauty17

Awind turbine is rotating counterclockwise at 0.5 rev/s and slows to a stop in 10 s. its blades are 20 m in length. (a) what is the angular acceleration of the turbine? (b) what is the centripetal acceleration of the tip of the blades at t=0s? (c) what is the magnitude and direction of the total linear acceleration of the tip of the blades at t=0s?

Answers: 1

continue

Physics, 22.06.2019 15:30, 2605098

Ametal ring 4.20 cm in diameter is placed between the north and south poles of large magnets with the plane of its area perpendicular to the magnetic field. these magnets produce an initial uniform field of 1.12 t between them but are gradually pulled apart, causing this field to remain uniform but decrease steadily at 0.240 t/s . (a) what is the magnitude of the electric field induced in the ring? (b) in which direction (clockwise or counterclockwise) does the current flow as viewed by someone on the south pole of the magnet?

Answers: 2

continue

Do you know the correct answer?

For the following sections assume concrete of compressive strength of 6,000 psi and reinforcing stee...