Physics, 01.10.2019 00:30, 22chandlerlashley

A.(6 pts.) draw a face-centered cubic unit cell. find the positions of the atoms, and the positions of the octahedral and tetrahedral voids within the structure. how many lattice sites, octahedral, and tetrahedral voids are contained in a cell? b.(6 pts.) let a material have the fcc structure, and consist of spherical atoms that just touch one another. what is the radius of the largest sphere that will fit inside an octahedral void without distorting the structure? what is the radius of the largest sphere that will fit in a tetrahedral void without distortion? [hint: the geometry of the tetrahedral void is much easier to treat if you first show that the center of the void lies at the center of a cube that is 1/8 the size of the fcc unit cell.]c.(6pts.) sketch the (101) of vanadium (v). treating the atoms as hard spheres, calculate the fraction of occupied area of this plane.

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 03:50, ash011519

The force acting on a beam was measured under the same operating conditions and a sample of 5 data points was collected. this process was repeated by 3 observers. the pooled standard deviations of these 3 data sets was 1.21. determine the true mean force using all pooled data (with a 95% probability). the result should look like this: true mean = mean +/- margin of error

Answers: 1

continue

Physics, 22.06.2019 06:30, keidyhernandezm

Which features on mars point to the possibility of liquid water on the planet? impact craters with sharp rims volcanic cones with craters gullies and stream-like channels mountain ranges with faults

Answers: 1

continue

Physics, 22.06.2019 11:20, cjd1214812148

The ultracentrifuge is an important tool for separating and analyzing proteins. because of the enormous centripetal accelerations, the centrifuge must be carefully balanced, with each sample matched by a sample of identical mass on the opposite side. any difference in the masses of opposing samples creates a net force on the shaft of the rotor, potentially leading to a catastrophic failure of the apparatus. suppose a scientist makes a slight error in sample preparation and one sample has a mass 10 mg larger than the opposing sample. if the samples are 12 cm from the axis of the rotor and the ultracentrifuge spins at 70,000 rpm, what is the magnitude of the net force on the rotor due to the unbalanced samples? ( be thorough on your answer)

Answers: 3

continue

Physics, 22.06.2019 14:40, casie65

During the experiment if you could triple the breakaway magnetic force with all other quantities left unchanged, what is the new value for the critical velocity if it was v0 (initial velocity), initially? (b) now if you halved the radius with all other quantities left unchanged, what is the new critical velocity if it was v0 (initial velocity), initially? (c) if during the experiment, critical velocity quadrupled with all other quantities left unchanged, what is the new breakaway force if its magnitude was initially f0,?

Answers: 1

continue

Do you know the correct answer?

A.(6 pts.) draw a face-centered cubic unit cell. find the positions of the atoms, and the positions...