Physics, 30.09.2019 19:20, aisis21

Which statement is consistent with the findings from the lab in this lesson?
a. the density of the ball was 0.45 g/cm3, so it was made of scrap rubber. therefore, it could not be from the maya civilization.
b. the density of the ball was 1.1 g/cm3, so it was made of soft commercial rubber. therefore, it could be from the maya civilization.
c. the density of the ball was 0.90 g/cm3, there is insufficient evidence to narrow the type to caoutchouc. therefore, it could not be definitively said to be maya.
d. the density of the ball was 1.2 g/cm3, so it was made of a hard rubber. therefore, it could not be from the maya civilization.

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 06:20, jonmorton159

Clothing made of several thin layers of fabric with trapped air in between, often called ski clothing, is commonly used in cold climates because it is light, fashionable, and a very effective thermal insulator. so it is no surprise that such clothing has largely replaced thickand heavy old-fashioned coats. (a) consider a jacket made of five layers of 0.1-mm-thick synthetic fabric (k = 0.13 w/m·°c) with 1.5-mm-thick air space (k = 0.026 w/m·°c) between the layers. assuming the inner surface temperature of the jacket to be 28°c and the surface area to be 1.25 m2, determine the rate of heat loss through the jacket when the temperature of the outdoors is 0°c and the heat transfer coefficient at the outer surface is 25 w/m2·°c. (b) what would your response be if the jacket is made of a single layer of 0.5-mm-thick synthetic fabric? what should be the thickness of a wool fabric (k = 0.035 w/m·°c) if the person is to achieve the same level of thermal comfort wearing a thick wool coat instead of a five-layer ski jacket?

Answers: 1

continue

Physics, 22.06.2019 07:30, crodriguez87

Clothes dryer uses about 7 amps of current from a 240 volt line. how much power does it use?

Answers: 1

continue

Physics, 22.06.2019 16:20, jmackenzie7

How does a circuit breaker protect a refrigerator? a. when the current is too high, a metal strip in the fuse melts and opens the circuit. b. when the resistance is too high , a re-settable which opens a circuit c. when the current is too high , a re-settable switch opens the circuit d. when the resistance is too high a metal strip in the fuse melts and opens the circuit

Answers: 2

continue

Physics, 22.06.2019 19:30, rprest00

Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?

Answers: 3

continue

Do you know the correct answer?

Which statement is consistent with the findings from the lab in this lesson?
a. the density...