These uv photons can break chemical bonds in your skin to cause sunburn—a form of radiation damage. if the 305 nm radiation provides exactly the energy to break an average chemical bond in the skin, estimate the average energy of these bonds in kj/mol.

energy = 391.902 kJ /mol

Explanation:

given data

wavelength = 305 nm = 305 × m

to find out

average energy

solution

we know speed of light is 3 × m/s

so we find frequency here first by speed of light formyla

speed = wavelength × frequency

3 ×  = 305 × × frequency

frequency = 9.8360 ×

so energy is

energy = hf

here h = 6.62 × J-s

so

energy =  6.62 ×  × 9.8360 ×

energy = 6.51 × J

so

energy = 6.51 ×  × kJ/mol

energy = 391.902 kJ /mol

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

d eras and periods