Physics, 08.08.2019 21:30, katy3865

Which is likely to be more common in our galaxy: white dwarfs or black holes? why?

Answers: 2

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 14:20, jadahilbun01

A1-lb collar is attached to a spring and slides without friction along a circular rod in a vertical plane. the spring has an undeformed length of 5 in. and a constant k =25 lb/ft. knowing that the collar is released from being held at a determine, the speed of the collar and the normal force between the collar and the rod as the collar passes through b.

Answers: 3

continue

Physics, 22.06.2019 17:00, miya214

The chart shows the costs and shipping times for materials that a company needs to build a new product. which describes the best trade-off if the company needs to start building their product within the next two years? they should order the domestic materials because it is always best to choose the fastest shipping time. they should order the imported materials because it is always best to choose the lowest cost for materials. since the shipping time is longer, they should order the domestic materials because the additional cost is worth it to get the materials in time. even though the shipping time is longer, they should order the imported materials because they are less expensive and should arrive in plenty of time to build the product.

Answers: 1

continue

Physics, 22.06.2019 20:30, valenzueladomipay09u

Light from two different sources are incident upon the same side of a polarizing filter. light from one source is polarized with total intensity ip, while light from the other source is unpolarized with total intensity iu. as you rotate the polarizing filter through 360 degrees, the intensity of the transmitted light on the other side varies by a factor of 9. what is the relative intensity of the initial polarized source to the unpolarized source, or ip/iu?

Answers: 2

continue

Physics, 23.06.2019 00:00, garysingh7

Determine the largest intensity w of the uniform loading that can be applied to the frame without causing either the average normal stress or the average shear stress at section b–b to exceed σ=19 mpa and τ=24 mpa, respectively.