Ashaft is loaded in bending and torsion such that ma 5 70 n ? m, ta 5 45 n ? m, mm 5 55 n ? m, and tm 5 35 n ? m. for the shaft, su 5 700 mpa and sy 5 560 mpa, and a fully corrected endurance limit of se 5 210 mpa is assumed. let kf 5 2.2 and kfs 5 1.8. with a design factor of 2.0 determine the minimum acceptable diameter of the shaft using the (a) de-gerber criterion. (b) de-asme elliptic criterion. (c) de-soderberg criterion. (d) de-goodman criterion. discuss and compare the results.

The two required components for a generator are

Aturntable a is built into a stage for use in a theatrical production. it is observed during a rehearsal that a trunk b starts to slide on the turntable 10 s after the turntable begins to rotate. knowing that the trunk undergoes a constant tangential acceleration of 0.31 m/s2, determine the coefficient of static friction between the trunk and the turntable.

Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question