Physics, 31.07.2019 17:20, pearlvldz

Aperson bends over to grab a 20 kg object. the back muscle responsible for supporting his upper body weight and the object is located 2/3 of the way up his back (where it attaches to the spine) and makes an angle of 12 degrees with the spine. his upper body weighs 36 n. what is the tension in the back muscle?
a. 1500 n
b. 1700 n
c. 2700 n
d. 3500 n

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 05:30, yiikes4012

Will give brainliest! which statement best describes the difference between strong nuclear forces and weak nuclear forces? weak nuclear forces are involved when certain types of atoms break down. strong nuclear forces are responsible for holding atoms' nucleus together. weak nuclear forces hold bonds between atoms together. strong nuclear forces hold together the nucleus of an atom. strong nuclear bonds prevent atoms from falling apart. weak nuclear bonds prevent compounds from falling apart. strong nuclear forces are involved in breaking electrons from their shells. weak nuclear forces hold protons in the nucleus.

Answers: 3

continue

Physics, 22.06.2019 06:20, lolweapon

Atwo-stage air compressor operates at steady state, compression 10m^3/min of air from 100 kpa and 300k to 1200 kpa. an intercooler between the two stages cools the air to 300k at a constant pressure of 350 kpa. the compression processes are isentropic. a) calculate the power required to run the compressor, in kw b) compare the result to the power required for isentropic compression from the same inlet state to the same final pressure.

Answers: 1

continue

Physics, 22.06.2019 10:30, SauceyNaee

Aparticle moves in the xy plane with constant acceleration. at time zero, the particle is at x = 6 m, y = 8.5 m, and has velocity ~vo = (9 m/s) ˆı + (−2.5 m/s) ˆ . the acceleration is given by ~a = (4.5 m/s 2 ) ˆı + (3 m/s 2 ) ˆ . what is the x component of velocity after 3.5 s? answer in units of m/s.

Answers: 1

continue

Physics, 22.06.2019 12:30, decemberbooker2505

Brades exam guidelines exam instructions billing & payments & support question 6 of 20 : select the best answer for the question use this illustration to answer the question below. forms & resources al programs 9 ww linics 6. in the circuit shown in the figure above, suppose that the value of r, is 100k, and the value of r2 is 470 kq. at which of the following locations in the circuit would you measure the highest voltage with your meter? rvices 999999 a. between points b and c b. between points a and b c. between points b and e d. between points a and c eredu mark for review (will be highlighted on the review page) mend < < previous question next question

Answers: 1

continue

Do you know the correct answer?

Aperson bends over to grab a 20 kg object. the back muscle responsible for supporting his upper body...