Physics, 05.07.2019 04:30, alegora78

Mopeds (small motorcycles with an engine capacity below 50 cm3) are very popular in europe because of their mobility, ease of operation, and low cost. the article “procedure to verify the maximum speed of automatic transmission mopeds in periodic motor vehicle inspections” (j. of automobile engr., 2008: 1615–1623) described a rolling bench test for determining maximum vehicle speed. a normal distribution with mean value 46.8 km/h and standard deviation 1.75 km/h is postulated. consider randomly selecting a single such moped. a. what is the probability that maximum speed is at most 50 km/h? b. what is the probability that maximum speed is at least 48 km/h? c. what is the probability that maximum speed differs from the mean value by at most 1.5 standard deviations?

Answers: 1

Show answers

Other questions on the subject: Physics

Physics, 22.06.2019 00:30, juansantos7b

Using the work energy theorem. what is the velocity of a 850kg car after starting at rest when 13,000j of work is done to it.

Answers: 1

continue

Physics, 22.06.2019 03:50, ash011519

The force acting on a beam was measured under the same operating conditions and a sample of 5 data points was collected. this process was repeated by 3 observers. the pooled standard deviations of these 3 data sets was 1.21. determine the true mean force using all pooled data (with a 95% probability). the result should look like this: true mean = mean +/- margin of error

Answers: 1

continue

Physics, 22.06.2019 06:20, lolweapon

Atwo-stage air compressor operates at steady state, compression 10m^3/min of air from 100 kpa and 300k to 1200 kpa. an intercooler between the two stages cools the air to 300k at a constant pressure of 350 kpa. the compression processes are isentropic. a) calculate the power required to run the compressor, in kw b) compare the result to the power required for isentropic compression from the same inlet state to the same final pressure.

Answers: 1

continue

Physics, 22.06.2019 09:00, montgomeryaevans

This is really important 1.which of the following prefixes represents the largest value? (2 points)gigahectorkilomilli2.which of the following types of graphs is best for plotting the mean, median, and mode of data? (2 points)bar graphbox-and-whiskercircle graphstem-and-leaf

Answers: 1

continue

Do you know the correct answer?

Mopeds (small motorcycles with an engine capacity below 50 cm3) are very popular in europe because o...