Physics
Physics, 25.06.2019 01:20, jesus3426

Ascanning tunneling microscope is used to measure small changes in height of a surface by detecting changes in the tunneling current between the tip and the surface. the current is proportional to the tunneling coefficient (ie. i = const * t) which follows the general equation for tunneling through a square well , with c dependent on the molecule and l is the distance. the transmission coefficient at one point is t = 0.01, what is the relative current if the distance is increased from l to 5l? we are interested in i(5l)/i(l). (note: there may be more information provided than you need to solve the problem.)

answer
Answers: 3

Other questions on the subject: Physics

image
Physics, 22.06.2019 01:00, anna4060
First, launch the video below. you will be asked to use your knowledge of physics to predict the outcome of an experiment. then, close the video window and answer the question at right. you can watch the video again at any point. part a as in the video, we apply a charge +q to the half-shell that carries the electroscope. this time, we also apply a charge –q to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? view available hint(s) as in the video, we apply a charge + to the half-shell that carries the electroscope. this time, we also apply a charge – to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? it deflects more than it did at the end of the video. it deflects the same amount as at end of the video. it does not deflect at all. it deflects less than it did at the end of the video. submit
Answers: 2
image
Physics, 22.06.2019 03:40, srtero
Aprojectile is launched from ground level with an initial velocity of v 0 feet per second. neglecting air resistance, its height in feet t seconds after launch is given by s equals negative 16 t squared plus v 0 t. find the time(s) that the projectile will (a) reach a height of 192 ft and (b) return to the ground when v 0equals112 feet per second. (a) find the time(s) that the projectile will reach a height of 192 ft when v 0equals112 feet per second. select the correct choice below and, if necessary, fill in the answer box to complete your choice.
Answers: 1
image
Physics, 22.06.2019 12:30, dee2970
Write a full page that sumerizes thermodynamics it’s from the website visionlearnig
Answers: 1
image
Physics, 22.06.2019 23:00, hannah1072
Imagine an isolated positive point charge q (many times larger than the charge on a single proton). there is a charged particle a (whose charge is much smaller than charge q) at a distance from the point charge q. on which of the following quantities does the magnitude of the electric field created by charge q at particle a's position depend? check all that apply. the type of the charge on the charged particle athe relative orientation between q and a (while the distance between q and a is fixed)the specific location of the charged particle a (while the distance between q and a is fixed)the amount of the charge on the point charge qthe specific location of the point charge q (while the distance between q and a is fixed)the distance between the point charge q and the charged particle athe amount of the charge on the charged particle a
Answers: 3
Do you know the correct answer?
Ascanning tunneling microscope is used to measure small changes in height of a surface by detecting...

Questions in other subjects:

Konu
English, 01.12.2021 22:50
Konu
Mathematics, 01.12.2021 22:50