Physics
Physics, 02.02.2020 18:54, groweisa

Atypical laboratory centrifuge rotates at 4100 rpm . test tubes have to be placed into a centrifuge very carefully because of the very large accelerations. part a what is the acceleration at the end of a test tube that is 10 cm from the axis of rotation? express your answer with the appropriate units.

answer
Answers: 1

Other questions on the subject: Physics

image
Physics, 22.06.2019 08:00, booitsmrradl3385
While studying chemical reactions and conservation of matter, sarah's class conducted a variety of experiments. sarah and her lab partner found the mass of a wax candle and placed the candle in a flask. the students lit the candle and let it burn to completion. all that was left was wax and charred candle wick. per their teacher's instructions, the students found the mass of the products. their data can be seen in the data table. formulate a hypothesis the students could test to explain why the experiment did not support the law of conservation of matter. a) the students could repeat the experiment using different candles; there might have been a flaw in the candle. b) the experiment should be repeatable. the students should run several trials and then take an average of the after mass in each trial. c) the students should have someone in the class check their measurement skills as they repeat the experiment. they may have made an error using the balance. d) the students should burn the candle in a container that has some type of lid so that any gas that is a product of the reaction can be contained and massed. submit
Answers: 2
image
Physics, 22.06.2019 09:10, melody32
The diagram shows a series of volcanic island and a hot spot determine the direction of movement of the tectonic plate that for the island
Answers: 2
image
Physics, 22.06.2019 09:30, xxtonixwilsonxx
True or false graphs must include scales that increase by the same amount
Answers: 1
image
Physics, 22.06.2019 21:40, iancuteodora30
Ahair dryer is basically a duct in which a few layers of electric resistors are placed. a small fan pulls the air in and forces it through the resistors where it is heated. air enters a 1200 w hair dryer at 100 kpa and 22°c and leaves at 47°c. the cross-sectional area of the hair dryer at the exit is 60 cm2. neglecting the power consumed by the fan and the heat losses through the walls of the hair dryer, determine (a) the volume flow rate of air at the inlet and (b) the velocity of the air at the exit.
Answers: 1
Do you know the correct answer?
Atypical laboratory centrifuge rotates at 4100 rpm . test tubes have to be placed into a centrifuge...

Questions in other subjects:

Konu
Mathematics, 20.11.2020 21:10