Mathematics
Mathematics, 15.03.2022 14:00, megnik0714

The target dimension for this part is: 3.701 . So most of the parts will cluster normally around 3.701 inches in length. At the time when the parts were being manufactured, Engineering had determined that a tolerance of ± 0.037 would be acceptable. i. e. the part would work well if it measured somewhere between 3.664 inches and 3.738 inches. Anything beyond the 3.738 in. would cause "sticking problems". Assuming that each cavity produces the same number of parts, estimate the percent of all the products (parts from all cavities) that could be sticking.


The target dimension for this part is: 3.701 . So most of the parts will cluster normally around 3.

answer
Answers: 1

Other questions on the subject: Mathematics

image
Mathematics, 21.06.2019 13:40, cherri319
Cam bought some used books for $4.95. he paid $0.50 each for some books and $0.35 each for the others. he bought fewer than 8 books at each price. how many books did cam buy?
Answers: 1
image
Mathematics, 21.06.2019 18:30, locomexicano03
The distance between two cities is 368 miles. if the scale on the map is 1/4 inch=23 miles, what is the distance between the cities on the map?
Answers: 3
image
Mathematics, 21.06.2019 19:30, fantasticratz2
Nikolas calculated the volume of the prism. his work is shown below.
Answers: 1
image
Mathematics, 21.06.2019 20:30, yfgkeyonna
On a cm grid, point p has coordinates (3,-1) and point q has coordinates (-5,6) calculate the shortest distance between p and q give your answer to 1 decimal place
Answers: 2
Do you know the correct answer?
The target dimension for this part is: 3.701 . So most of the parts will cluster normally around 3.7...

Questions in other subjects:

Konu
Mathematics, 07.07.2019 02:40
Konu
Social Studies, 07.07.2019 02:40