A machining center is in charge of producing 225 parts per day. The parts width. Any parts produced between 250mm and 260mm are considered gless than 250mm must be reworked at an additional cost of $8 per part. 260mm must be reworked at an additional cost of $2.50 per part. The varquantified as a standard deviation of 5.0mm. Measurements on these parhave the ability to set up the machine to achieve whatever mean width value you wish. Required:
Setup a data table to determine the mean width setting that will minimize expected rework cost ($8 per small part and $2.50 per large part).