In the diagram below, segment MN is the image of segment AB after a dilation with a center at point C. Which of the following ratios would represent the scale factor? 1. AB/BC
2. AB/MN
3. AM/CM
4. CN/CB

You are assembling pieces of an iron gate to complete a fence. the finished gate will look like the one below. in order to assemble the gate it is important to under how the pieces are related. part 1: how are pies 1 and 2 in the archway related? part 2: how are the rectangular sections 5 and 6 in the center of the gate related to each other?

The lengths of nails produced in a factory are normally distributed with a mean of 4.91 centimeters and a standard deviation of 0.05 centimeters. find the two lengths that separate the top 4% and the bottom 4%. these lengths could serve as limits used to identify which nails should be rejected. round your answer to the nearest hundredth, if necessary.

You drop a rubber ball off the roof of a 50 meter high building onto a paved parking lot. it bounces back up with every bounce, but not quite all the way back up to you. after the first bounce it bounces back only 80 percent of the distance it was dropped from. the pattern continues, meaning after every bounce it comes up to just 80 percent of the previous maximum height. so if before the first bounce the height is 50 meters, what height does the ball reach after the fifth bounce? round your answer to one decimal place and chose the correct response from the choices below: