Mathematics, 17.10.2019 13:30, nanakwameyeb

If two angles are supplementary and one of the angles measures 62°, what is the measure of the other angle? 28° 38° 118° 128°

Answers: 3

Show answers

Other questions on the subject: Mathematics

Mathematics, 20.06.2019 18:04, andrewsaul04

Yuri, sam and dani had the same math homework last night, but none of them finished it. yuri finished 3/8 of her homework, sam finished 4/6 of her homework and dani finished 1/2. who finished the most math homework? who finished the least amount?

Answers: 1

continue

Mathematics, 21.06.2019 15:20, poreally1446

If x=-3 is the only x-intercept of the graph of a quadratic equation, which statement best discribes the discriminant of the equation?

Answers: 1

continue

Mathematics, 21.06.2019 18:30, millie54

Create a data set with 8 points in it that has a mean of approximately 10 and a standard deviation of approximately 1.

Answers: 1

continue

Mathematics, 21.06.2019 19:00, priscillaan

Solve 3x-18=2y and 5x-6y=14 by elimination or substitution . show all !

Answers: 1

continue

Do you know the correct answer?

If two angles are supplementary and one of the angles measures 62°, what is the measure of the other...

Questions in other subjects:

Engineering, 26.07.2019 19:10

Arectangular block having dimensions 20 cm x 30 cm x 40 cm is subjected to a hydrostatic stress of -50 kpa (i. e. under compression). calculate the change in length of each side. d...

Engineering, 26.07.2019 19:10

Astainless steel (sae 301) wire is stretched between rigid supports so that a stress of 40 mpa is induced in the wire at a temperature of 20°c. what would be the stress at a temper...

Engineering, 26.07.2019 19:10

During sheet metal bending, springback is the increase in bend angle and the increase in bend radius. the increase in bend angle and the decrease in bend radius. the decrease in be...

Engineering, 26.07.2019 19:10

Avehicle of 1 200 kg is moving at a speed of 40 km/h on an incline of 1 in 50. the total constant rolling and wind resistance is 600 n. the efficiency of the drive from the engine...

Engineering, 26.07.2019 19:10

Using a 2-d mohr's circle, prove the relationship between the elastic modulus e, shear modulus g and poisson ratio is given by the equation e=2g(1+v )....

Engineering, 26.07.2019 19:10

Consider a pb-40 %sn alloy. determine the composition of the first solid to form during solidification. (i) (ii) the amounts and composition of each phase at 184°c the amounts and...

Engineering, 26.07.2019 19:10

Why might peck drilling be used instead of standard drilling with a 0.25" diameter hole which is 3 inches deep on a aluminum part? a. to save time b. to reduce temperature and too...

Engineering, 26.07.2019 19:10

Amulti-plate clutch connects two in-line shafts, through 4 plates on the driving and 3 plates driven shaft. the plates have inner and outer diameters 120 and 180mm respectively, wi...

Engineering, 26.07.2019 19:10

Ametal sphere of 6- in internal diameter is weighed on a beam balance when it is empty (all gas evacuated be- fore weighing). it is then filled with an unknown gas to a pressure of...

Engineering, 26.07.2019 19:10

Afour-cylinder, two-stroke 2.4-l diesel engine that operates on an ideal diesel cycle has a compression ratio of 22 and a cutoff ratio of 1.8. air is at 70°c and 97 kpa at the begi...

Other tasks in the category: Mathematics More task