Mathematics, 29.03.2021 20:00, khalaflaf9381

The diameters of bolts produced in a machine shop are normally distributed with a mean of 6.48 millimeters and a standard deviation of 0.06 millimeters. Find the two diameters that separate the top 3% and the bottom 3%. These diameters could serve as limits used to identify which bolts should be rejected. Round your answer to the nearest hundredth, if necessary.

Answers: 2

Show answers

Other questions on the subject: Mathematics

Mathematics, 21.06.2019 14:10, shygrl05

What is the value of the digit 1 in the number 13?

Answers: 2

continue

Mathematics, 21.06.2019 16:30, danjan9084

One of the same side angles of two parallel lines is 20° smaller than the other one. find the measures of these two angles.

Answers: 3

continue

Mathematics, 21.06.2019 21:40, jasmine8142002

Atransformation t : (x, y) (x-5,y +3) the image of a(2,-1) is

Answers: 1

continue

Mathematics, 21.06.2019 22:00, Jasten

Set $r$ is a set of rectangles such that (1) only the grid points shown here are used as vertices, (2) all sides are vertical or horizontal and (3) no two rectangles in the set are congruent. if $r$ contains the maximum possible number of rectangles given these conditions, what fraction of the rectangles in set $r$ are squares? express your answer as a common fraction.

Answers: 1

continue

Do you know the correct answer?

The diameters of bolts produced in a machine shop are normally distributed with a mean of 6.48 milli...