Simplify the following

the required function is .

step-by-step explanation:

from the given table it is noticed that the graph passing through (-3,7), (0,4), (3,1) and (8,-4).

it is a linear function because the value of y is decrease by one as the value of x increase by 1.

the slope of the function is

the slope of the function is -1 and the y-intercept is 4.

the slope intercept form is

where, m is slope and b is y-intercept.

therefore the required function is . the graph of this function is shown below.

2/3

step-by-step explanation:

the slope of a line is equal to the rise/run. in this case the line rises 2 units for every +3 units it moves

2 & 7

step-by-step explanation:

he climbs 300 ft/hr at a constant rate. the peak is at 1,500 ft.

when going up, he reaches 600 ft in 2 hours. remember, that he is going in a constant rate. divide 600 with 300:

600/300 = 2

assuming that he takes the same route back (meaning that it's a 1500 ft route back, you can solve.

note also that you are solving when he gets back to 600 ft after he reaches the peak.

first, find the amount of hours it takes to get up the peak. divide the total amount (1500), with the ft/her (300) to get the amount of hours (x):

1500/300 = x

x = 5

it takes jamie 5 hours to get up. now, he is returning down, and reaches 600 (his current destination). remember that he climbs at a constant 300 ft/hr. divide 600 with 300:

600/300 = x

x = 2

now add the two numbers together.

x = 5 + 2 = 7

jamie takes 7 hours to go up the mountain and reach his current position when descending.

(total amount/constant rate) = (time).

remember that it is a constant rate, so in total, when he gets back down the mountain, it will take the same amount of time as when he goes up. the total amount for the round trip is: 5 + 5 = 10.

~

when rotating a figure 180 degrees, imagine that you are able to take the figure and turn it clockwise or counterclockwise around a center point. to rotate a figure 180 degrees, you will need to apply the rule (x, y) → (-x, -y). start by using a coordinate grid with coordinates for each vertex of the figure. the center point of the coordinate grid is located at (0, 0), which is what you will rotate the figure around. write down the original coordinates of the shape you are going to rotate. then, apply the rule. for example, coordinate (1, 2) becomes (-1, -2). another example would be, coordinate (-4, -2) becoming (4, 2). after you change each original coordinate to the rotated coordinate, you will draw your new figure.

step-by-step explanation: