Mathematics, 22.05.2020 02:11, gipoletti1315

Which of the following polynomial functions is graphed below?

Answers: 1

Show answers

Other questions on the subject: Mathematics

Mathematics, 21.06.2019 22:30, babyskitt

Which answer goes into the box? (90° clockwise rotation, 90° counter clockwise rotation, translation, or glide reflection)

Answers: 2

continue

Mathematics, 21.06.2019 23:40, redhot12352

For a science project, a high school research team conducted a survey of local air temperatures. based on the results of the survey, the found that the average temperatures were around 10 degrees higher than expected. this result was wrong. the trouble with the survey was that most of the locations were exposed to direct sunlight and located over asphalt or sand, which resulted in higher temperatures than normal. this is a classic example of an error in which phase of inferential statistics?

Answers: 1

continue

Mathematics, 22.06.2019 00:30, gthif13211

I've been working on this for a few days and i just don't understand, it's due in a few hours. you. the direction of a vector is defined as the angle of the vector in relation to a horizontal line. as a standard, this angle is measured counterclockwise from the positive x-axis. the direction or angle of v in the diagram is α. part a: how can you use trigonometric ratios to calculate the direction α of a general vector v = < x, y> similar to the diagram? part b suppose that vector v lies in quadrant ii, quadrant iii, or quadrant iv. how can you use trigonometric ratios to calculate the direction (i. e., angle) of the vector in each of these quadrants with respect to the positive x-axis? the angle between the vector and the positive x-axis will be greater than 90 degrees in each case. part c now try a numerical problem. what is the direction of the vector w = < -1, 6 > ?

Answers: 1

continue

Mathematics, 22.06.2019 02:00, samarahbrown6050

Graph a triangle (xyz) and reflect it over the line y=x to create triangle x’y’z’. describe the transformation using words. draw a line segment from point x to the reflecting line, and then draw a line segment from point x’ to the reflecting line. what do you notice about the two line segments you drew? do you think you would see the same characteristics if you drew the line segment connecting y with the reflecting line and then y’ with the reflecting line? how do you know?