The hammer of a pile driver of mass 2000kg falls freely through a distance of 4.5m onto a pile
and drives it 50 mm into the ground. the impact takes place in 0.015 seconds and the hammer
does not rebound. determine the average applied force exerted on to the pile hammer. note,
| because the force is applied over a short time period it can be considered as an impulse force.

median is the value separating the higher half of a data sample, a population or probablity distribution from the lower half.

step-by-step explanation:

say you have 3,8,7,3,1,9,8 order them from lowest to highest

if orderd it would be 1,3,3,7,8,8,9 now you take away from the lowest and the highest until you end up in the middle.

so you would remove the 1 and 9 leaving you with 5 digits remaining

when you've reached the middle that would be your answer so in this case the answer is 7

if there were two numbers left say 7 and 5 you'd and them together so 12 then divide by 2 witch would equal 6 so the answer would be 6

good luck on that project hoped i you at all

- "runner b is moving at a slower rate."

- "the graphs shown are graphs of distance(km) against time(min).

the slopes of this graphs are are given by:

slope = (change in y)/(change in x)

= (change in distance)/(change in time)

this is the formula for finding the speed. so, the slope of these graphs represent the speed of the runner.

taking each division in the graph to represent 1 on both axis:

runner a ⇒ speed = (2-0)/(1-0)

= 2/1

= 2 km/min

runner b ⇒ speed = (3-0)/(3-0)

= 3/3

= 1 km/min

this shows that   runner b is moving at a slower rate."

(b) 240

step-by-step explanation:

first, we use the pythagorean formula using the given side lengths to find x. then we use x to find the side lengths. then we add the side lengths to find the perimeter.

pythagorean theorem formula:

a^2 + b^2 = c^2

(x - 20)^2 + (x - 40)^2 = x^2

x^2 - 40x + 400 + x^2 - 80x + 1600 = x^2

x^2 -120x + 2000 = 0

(x - 100)(x - 20) = 0

x - 100 = 0 or x - 20 = 0

x = 100 or x = 20

we see that the solution x = 20 must be discarded because it will give a negative side length and a side length of 0. the only valid solution is x = 100.

perimeter = sum of the lengths of the sides

perimeter = x + x - 20 + x - 40

perimeter = 3x - 60

replace x with 100.

perimeter = 3(100) - 60

perimeter = 300 - 60

perimeter = 240

$75.00

step-by-step explanation:

i = prt

i = 1,5000 * 0.025 * 2

i = 75