Question 3 multiple choice worth 1 points)
(01.02 lc)
when copying segments and angles, which step is the same?
draw a ray with one endpoint.
create a point outside of the original figure.
draw a ray from the vertex to another point.
create a point on the original figure.

The answer above is correct its: Draw a ray with one end point

Step-by-step explanation:

An instructor is shown in front of a whiteboard. The instructor uses the following steps to copy an angle.

You are given an angle.

Draw a ray with one endpoint. This endpoint will be the vertex of the new angle.

Place the compass on the vertex of the given angle, and swing an arc that intersects both rays of the given angle.

Place the compass on the vertex of the new angle, and swing an arc similar to the first one you created.

Open the compass to the width of the intersection points of the rays and arc of the given angle.

Place the compass on the intersection point of the ray and arc of the new angle, and swing another arc that intersects the first.

Draw a ray through the new vertex and the intersection point of the two rays.

This second ray creates an angle that is congruent to the given one.

An instructor is shown in front of a whiteboard. The instructor uses the following steps to bisect a segment.

You are given a segment with two endpoints.

Place the compass on one of the endpoints and open the compass to a distance more than halfway across the segment.

Swing an arc on either side of the segment.

Keeping the compass at the same width, place the compass on the other endpoint and swing arcs on either side so that they intersect the first two arcs created.

Mark the intersection points of the arcs and draw a line through those two points.

The point where this new line crosses the given segment is the midpoint and divides the segment in half.

  Draw a ray with one endpoint.

Step-by-step explanation:

For each construction, you need a line with a point on it to start from. A ray with one endpoint will do.

__

Copying a segment, you mark off the length of the original segment on the ray.

Copying an angle, you use the ray as the vertex and one side of the new angle.