Engineering, 14.04.2022 06:10, jmackenzie7

A single packed bed reactor is to be designed to process 100 mol/s of reactant A so as to produce product R. Feed gas at 2.49 MPa and 300 K, the allowable Tmax = 900 K, unless otherwise noted, Tmin= 300 K, the product stream is wanted at 300 K, and the thermodynamics and kinetics of the exothermic reaction are given to us in Fig. 19.11. Prepare a sketch of your recommended design and on it show a .The flow arrangement selected: plug, or mixed flow reactor b. Weight of catalyst needed
c. Heat duty ahead of the reactor, at the reactor itself, and after the reactor
d. Temperature of all flowing streams Work out a good design for 80% conversion of a feed consisting of 1 mole A and 7 moles of inert, with Cp = 40 J/mol. K

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, lerasteidl

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

continue

Engineering, 04.07.2019 18:10, mirmir62

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

continue

Engineering, 04.07.2019 18:10, QueenLife4869

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Do you know the correct answer?

A single packed bed reactor is to be designed to process 100 mol/s of reactant A so as to produce pr...