Engineering
Engineering, 02.02.2022 01:00, blackbetty79

A rock, shaped like the rock sits in a desert in Iraq. The rock has a surface area of 3m^2, and heats up to 55C during the day. The air temperature at night is 10C. IF the rock gives off heat at a power of 10C. If the rock gives off heat at a power of 140W, what is the emissivity of the rock.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
image
Engineering, 04.07.2019 19:20, natalie2sheffield
Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference
Answers: 3
image
Engineering, 06.07.2019 03:10, kturvey225
Consider a 1.2 meter high and 2 meter wide glass window whose thickness is 6 mm and thermal conductivity is 0.78 w/m °c. the room temperature is maintained at 24 °c, while the outdoor temperature is -5 °c. the convective heat transfer coefficients on the inner and outer surfaces of the window are 10 w/m2 °c and 25 w/m2 °c respectively. (a) draw the thermal resistance network, etermine the steady rate of heat transfer t e glass window (c) determine the temperature of the inner surface of the window
Answers: 3
image
Engineering, 06.07.2019 03:20, shelbellingswo
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
Do you know the correct answer?
A rock, shaped like the rock sits in a desert in Iraq. The rock has a surface area of 3m^2, and heat...

Questions in other subjects: