Using oxygen as the orifice gas?
a. decreases dross on the bottom surface of the cut
b...
Engineering, 25.12.2021 03:30, Angelofpink2590
Using oxygen as the orifice gas?
a. decreases dross on the bottom surface of the cut
b. increases the cutting speed when cutting stainless steel
c. eliminates hot shortness when cutting aluminum
d. increases the cutting speed when cutting carbon steel
Answers: 3
Engineering, 03.07.2019 15:10, margaret1758
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:20, rjone8429
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Mathematics, 28.10.2020 18:40
English, 28.10.2020 18:40
Biology, 28.10.2020 18:40
Biology, 28.10.2020 18:40