Engineering
Engineering, 20.12.2021 14:00, realneggalloyd

A settling column analysis is performed on a dilute suspension of particles from water. The suspension exhibited discrete particle settling characteristics. Data collected from samples taken at a depth 1.5 m as follows: Settling time (min) 0.6 1.2 2.2 4.5 6.0 8.8
Fraction of particles settled 0.30 0.45 0.60 0.70 0.85 0.96
a. Plot the velocity distribution for the suspension
b. Find the overflow rate (Q/A) for a settling tank that will give at least 75 % removal
c. Assuming the feed flow rate is 850 m3//hr., determine the dimension of the settling tank.
d. What is the particle size distribution (mass fraction vs. diameter) if we assume the particle density is that of sand (sg = 2.65)

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 19:10, lexie223
Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.
Answers: 2
image
Engineering, 04.07.2019 19:20, justicehernandez
Acarnot refrigerator operates in a room in which the temperature is 21°c and of power when operating. if the food compartment of the refrigerator is consumes 3 kw to be maintained at 2°c, determine (a) the coefficient of performance of the cycle and (b) the rate of heat removal from the food compartment. refrigerator cycle that has a higher coefficient of performance than that of the discussed (e) is it possible to develop a carn ot refrigerator, operating between the same temperature limits? explain
Answers: 2
image
Engineering, 06.07.2019 04:20, Okeh4001
An insulated tank truck containing 50,000 pounds of double-distilled, deionized water at 30 °c is pumped into a closed, refrigerated storage tank maintained at 5 °c in a facility located on top of mount mitchell, north carolina (elevation 6,684 feet & average july temperature of 84 °f). a)-determine the volume of the storage tank required to hold the purified water. b)- determine the initial and final pressure differences that must be overcome by a liquid pump assuming the storage tank initially contains air at 5 °c. assume the air is slowly bled out of the storage tank during the water transfer c.) during a routine operation today, the tank is slightly ruptured by a stainless steel pipe and a water acrosol of droplets begins to spray out of the storage tank. state all assumptions and determine the internal pressure within the water droplets produced
Answers: 1
image
Engineering, 06.07.2019 04:20, butt1562
Consider the transfer function for a first-order system g(s)=12(s+7)/(s^2+2s+9) for this system determine: a) poles and zeros of the function, b) the natural frequency and damping ratio, c) the peak value achieved in response to a unit step input, d) the peak time for a unit step input, e) the steady-state system response to a unit step input
Answers: 2
Do you know the correct answer?
A settling column analysis is performed on a dilute suspension of particles from water. The suspensi...

Questions in other subjects: