Engineering, 16.12.2021 23:50, brittinyvenegas
31.A satisfactory radiograph is produced as follows: Single phase-2 pulse, 80kVp, 25 mAs, 72inch SID, 12:1 grid, 200 RSV. A new radiograph is to be produced with the following changes: 3-Phase-12 pulse, 68kVp, 8:1 grid, and 400 RSV. What changes should be made to maintain the original density?
Answers: 1
Engineering, 03.07.2019 15:10, margaret1758
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 19:10, juneham
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
Engineering, 04.07.2019 19:20, mercedesamatap21hx0
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
31.A satisfactory radiograph is produced as follows: Single phase-2 pulse, 80kVp, 25 mAs, 72inch SID...
SAT, 14.12.2021 03:10
Social Studies, 14.12.2021 03:20
Social Studies, 14.12.2021 03:20
Mathematics, 14.12.2021 03:20
English, 14.12.2021 03:20
History, 14.12.2021 03:20