Engineering
Engineering, 11.12.2021 19:10, stephycake9768

What's More Let's try composing melodies in Key of C, G,and F major.

Activity 1
What are three (3) things that you are thankful for?

1._ 2._ 3._

Follow the steps to create self composed melody.

1.Fill out the missing words below the staff.
2.Create a simple melody to the words. One note for each syllable.
3.Take note that in a 4/4 time signature there are four beats in a measure and a quarter note receives one beat.
4.Uss the first five notes (do, re, mi, fa, so) in the key of C. You can use it in any order.
5.Use half notes and quarter notes only.
6.Use steps and repeated melodic direction
7.The first and last note of the melody is lower do.
8.Check the rubrics to evaluate your performance.


What's More

Let's try composing melodies in Key of C,G,and F major.Activity 1 What are three (3)

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
image
Engineering, 04.07.2019 18:10, salazjlove
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
image
Engineering, 04.07.2019 18:10, namira16
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Do you know the correct answer?
What's More Let's try composing melodies in Key of C, G,and F major.

Activity 1
W...

Questions in other subjects:

Konu
Mathematics, 24.05.2021 05:10