Engineering
Engineering, 09.12.2021 15:00, youngbeauty17

Air flows isentropically through a converging nozzle. At a station where the area is 0.013 ft2 , the local pressure, temperature and Mach number are 60 psia, 40 F and 0.52, respectively. Determine the Mach number at the throat, the throat area and mass flow rate when the back pressure is (a) 30 psia, (b) 45 psia.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
image
Engineering, 04.07.2019 19:10, batmanmarie2004
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
image
Engineering, 04.07.2019 19:20, lordcaos066
Determine the time of the day and month of the year at which the peak sensible cooling load occurs for a top floor, north-eastern corner room of an office building in durban for the following conditions: floor area: 8 x 8 x 3 m east and north walls: 115 mm face brick (outside), 20 mm air space, 115 mm ordinary brick (inside) with 15 mm plaster roof construction: suspended plasterboard ceiling, 450 mm air space, 150 mm concrete, 75mm screed, waterproofing no heat transfer across other surfaces window area 3x 1,5 m high in north wall only. ordinary glass with venetian blinds. lights and occupants : from 07: 00 to 18: 00 average light density: 25 w/m2 number of occupants : 5 seated, light office work room temperature 24°c
Answers: 3
image
Engineering, 06.07.2019 05:20, swordsman
Acantilever of 3 m length with a t-shaped cross-section is loaded by three concentrated loads: w,-80 n at the free end, w 30 n, and w,-60 n at a distance of 1 m from the free end. all loads are applied at the outer edges of the flange as indicated in the sketch below. (a)-determine the maximum torsional shear stresses in the flange and in the web at distances 0.5 m and 2.5 m from the free end (sections i and ii marked in the sketch) b)- determine thefh end cross section assuming a shear modulus of 210 gpa.
Answers: 3
Do you know the correct answer?
Air flows isentropically through a converging nozzle. At a station where the area is 0.013 ft2 , the...

Questions in other subjects: