Engineering, 02.12.2021 17:00, tyrique86
Figure 3 illustrates the stress-strain diagram for tensile test of four (4) different materials
and labelled as A, B, C and D. Each tested sample is 10 mm in diameter with a gauge
length of 50 mm. From the diagram,
i)
) Identify the material with the largest modulus of elasticity and state its value.
[2 Marks]
ii) Identify the material with the maximum ultimate tensile strength and state its value.
[2 Marks]
iii) Identify the material with the highest failure strength and state its value.
[2 Marks)
iv) Identify the material with the lowest yield strength and state its value.
[2 Marks]
v) Predict the suitable material among A, B, C and D for the used in construction.
Give TWO (2) reasons.
[2 Marks)
Answers: 1
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 19:10, justkevin1231
Which of the following is the most important advantage of a large field of view? a. allows larger areas to be examined b. relieves eyestrain c. minimizes parallax errors. d. increases precision in proportion to the in- crease in field of view
Answers: 2
Engineering, 04.07.2019 19:20, dndndndnxmnc
The process in which the system pressure remain constant is called a)-isobaric b)-isochoric c)-isolated d)-isothermal
Answers: 3
Figure 3 illustrates the stress-strain diagram for tensile test of four (4) different materials
an...
English, 07.12.2020 18:10
English, 07.12.2020 18:10
Chemistry, 07.12.2020 18:10
Mathematics, 07.12.2020 18:10
Biology, 07.12.2020 18:10