Engineering
Engineering, 29.11.2021 21:10, robertjoy19

Timber Design A timber building, using timber floor joists spanning 5.0m, are required to be loaded for a duration of medium-term loading. The timber floor with total dead loads of 1.55 kN/m' and 1. imposed live loads respectively is to be constructed on a simply supported timber floor joists of grade GS, Caribbean Pitch Pine. Ignoring the joists self-weight, select an adequate section to support the above loads for the joist which are spaced at 400mm centre to centre. The sections are also to be checked for bending, deflection and shear capacity.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
image
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
image
Engineering, 04.07.2019 19:10, jrcspiderman2003
Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?
Answers: 3
image
Engineering, 04.07.2019 19:10, nbug2121
Arigid tank contains 10 kg of air at 137 kpa (abs) and 21°c. more air is added to the tank until the pressure and temperature rise to 242 kpa (abs) and 32°c, respectively. determine the amount of air added to the tank. [r-0.287 kj/kg k]
Answers: 3
Do you know the correct answer?
Timber Design A timber building, using timber floor joists spanning 5.0m, are required to be loaded...

Questions in other subjects: