Engineering, 25.11.2021 08:20, DESTROYERMODE2308

The steady-state process gain for the actuator, main process and sensor, considered as a single process, is 5.0 gpm/mA. (a.5 pts.) Consider a P-only controller to be switched on and the proportional gain is 0.3 mA/gpm. What is the magnitude of the control signal sent to the actuator at 10 seconds

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, kayabwaller4589

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

continue

Engineering, 03.07.2019 15:10, brooklyn674

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

continue

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

Do you know the correct answer?

The steady-state process gain for the actuator, main process and sensor, considered as a single proc...