Engineering
Engineering, 25.11.2021 07:20, npaslayoy1bzj

A bending operation is performed on cold-rolled steel sheet in a V die. The die opening is 25 mm. The sheet is 4.0 mm thick and 25 mm wide. The tensile strength of the material is 300MPa. The resulting sheet metal part has an angle of 30 and a bend radius of 6 mm. Determine the bend allowance in mm.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, cowgyrlup124
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
image
Engineering, 03.07.2019 14:10, kayabwaller4589
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
image
Engineering, 04.07.2019 08:10, doggo242
Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed
Answers: 1
image
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Do you know the correct answer?
A bending operation is performed on cold-rolled steel sheet in a V die. The die opening is 25 mm. Th...

Questions in other subjects: