Engineering, 25.11.2021 06:20, PONBallfordM89

Why does the compression-refrigeration cycle have a high-pressure side and a low-pressure side? a. The pressure difference is the result of polar molecular alignment due to the intense magnetic field created by the compressor motor.

b. So the refrigerant can condense at a low pressure and temperature and evaporate at a high pressure and temperature

c. The pressure difference isn't intentionally created but is simply the result of circulating refrigerant within the compressor.

d. So the refrigerant can evaporate at a low pressure and temperature and condense at a high pressure and temperature

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 03:10, lauriepdx17

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Do you know the correct answer?

Why does the compression-refrigeration cycle have a high-pressure side and a low-pressure side? a....