Engineering
Engineering, 06.11.2021 02:40, kelseeygee

* 4. Annika’s class is investigating energy. They wonder what would happen to the temperature reading on a thermometer if they put the thermometer inside a mitten (see diagram A above). Both thermometers started at room temperature. Annika’s group obtained two thermometers and a mitten. They put one thermometer inside the mitten and the other thermometer on the table next to the mitten. An hour later they compared the readings on the two thermometers. The temperature inside the room remained the same during their experiment. The thermometer inside the mitten will have a lower temperature reading than the thermometer on the table because the mitten will conduct the cold air outside the thermometer. Both thermometers will have the same temperature reading because the mitten doesn’t generate additional heat. The thermometer inside the mitten will have a higher temperature reading than the thermometer on the table because the mitten will trap the warm air inside the mitten. The thermometer inside the mitten will have a higher temperature reading than the thermometer on the table because the mitten will insulate the thermometer.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, QueenLife4869
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
image
Engineering, 04.07.2019 18:20, mjcbs21
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
image
Engineering, 04.07.2019 18:20, AnonymousLizard52303
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
image
Engineering, 04.07.2019 19:10, gabigalvis1091
What is the main objective of using reheat rankine cycle?
Answers: 3
Do you know the correct answer?
* 4. Annika’s class is investigating energy. They wonder what would happen to the temperature readin...

Questions in other subjects:

Konu
Chemistry, 26.02.2020 00:41
Konu
Mathematics, 26.02.2020 00:41