Engineering, 20.10.2021 14:00, townselt3861

A detailed solution with reasoning is demanded... (a) By applying the relevant knowledge, the Total Solidification Times(TST) of three casting

shapes are to be calculated and compared: (1) a sphere with diameter 1⁄4 10 cm, (2) a cylinder with

diameter and length both 1⁄4 10 cm, and (3) a cube with each side1⁄410 cm. The same casting alloy

is used in the three cases. Determine the relative solidification times for each geometry. If the mold

constant 1⁄4 3.5 min/cm2 in Chvorinov’s rule, compute the total solidification time for each casting.

(b) Based on the results of part (a), which geometric element would make the best riser and why?

Present an analysis-based comment on the outcome.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, yasminothman02

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

continue

Engineering, 04.07.2019 18:10, abdirahmansoloman

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Do you know the correct answer?

A detailed solution with reasoning is demanded... (a) By applying the relevant knowledge, the Tota...