Engineering, 19.10.2021 06:50, penajay

All of the following statements related to the PDS "Check Sheet" are correct, EXCEPT: 1: The Pre-Delivery Service process and the "Check Sheet" consist of six parts, Before Inspection:
Functional Operation; Walkaround Inspection; Under Hood; Under Vehicle (On Hoist); Road Test.

2: The "PDS Bulletin" (master document) for the vehicle serviced includes a "hyperlink" to the PDS
"Check Sheet" for the vehicle designated in the TIS search.

3: Page two of the "Check Sheet" describes more detailed instructions for performing some of the
operations required during PDS.

4:The "Check Sheet" may have hyperlinks to Repair Manual procedures.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, agpraga23ovv65c

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

continue

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Do you know the correct answer?

All of the following statements related to the PDS "Check Sheet" are correct, EXCEPT: 1: The Pre-D...