Engineering, 26.09.2021 14:30, tsvijay121

As a machine shop owner, you are asked to produce parts are per drawing shown below. The part is to be waterjet cut from Aluminum (Al-6061-T6, density= 2.7 g/cm3) 0.063" thick plate stock costing
$12/pound. Water jet machine runs at a constant cutting speed of 200 mm/min, at an operating cost
of S20/hr.
1) Find the coordinate point of vertexes A to T to be used for CNC waterjet cutting machine.
2) Estimate the material cost per part.
3) Estimate the machining cost per part.
Drawing: All dimensions in inch. CNC starting point is at A= (2,2). Vertical dash line indicates line
of mirror symmetry

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, qwertylol12345

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:20, safiyabrowne7594

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

continue

Engineering, 04.07.2019 18:20, dlr1628

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

continue

Do you know the correct answer?

As a machine shop owner, you are asked to produce parts are per drawing shown below. The part is t...