Engineering, 03.09.2021 22:20, solikhalifeoy3j1r

you must develop a dynamic model based on fundamental principles for a pressure tank system as pictured below. You may assume that the total number of moles of gas in tank i, ni (t), may also be expressed as using the ideal gas law. All flow rates are molar flow rates. You can change valve position on the inlet stream u(t). You do not need to carry units throughout the problem, just try to make sure you have the correct terms in each balance. Derive a differential equation model for the system

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, bunnles

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:10, juansoto227711

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

continue

Do you know the correct answer?

you must develop a dynamic model based on fundamental principles for a pressure tank system as pictu...