Engineering, 29.08.2021 08:20, ripbobbyjackson6701

3 m high and 5 m wide wall consists of 16 cm × 22 cm cross-section horizontal bricks ( k = 0 7.2 W/m. K ) K separated by 3 cm thick mortar layers (k = 0.25 W/m. K) The brick wall also consists of 2 cm thick plaster (k = 0.22 W/m. K) layers on each side of brick and 3 cm thick rigid foam (k = 0.026 W/m. K) on the inner side of the wall as shown in Fig. 3.21(a). The indoor and outdoor temperatures are 55 and 25°C and convection heat transfer coefficients on inner and outer sides 10 W/m^2.W/m 2
.K and 25 W/m^2.KW/m
2
.K, respectively. Assume one dimensional heat transfer and disregard radiation, determine the rate of heat transfer through the wall.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, Larkinlover703

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

continue

Do you know the correct answer?

3 m high and 5 m wide wall consists of 16 cm × 22 cm cross-section horizontal bricks ( k = 0 7.2 W/m...