Engineering, 26.08.2021 20:40, kang39

A double-threaded Acme stub screw of known major diameter is used in ajack having a plain thrust collar of known mean diameter. Coefficients of running friction are estimated as 0.10 for the collar and 0.11 for the screw. Assume (1) the starting friction is about 1/3 higher than running friction and (2) the screw is not exposed to vibration. Required:
a. Determine the pitch, lead, thread depth, mean pitch diameter, and helix angle of the screw.
b. Estimate the starting torque for raising and for lowering a 5000 lb load.
c. If the screw is lifting a 5000 lb load at the rate of 4 ft/min, what is the screw rpm? What is the efficiency of the jack under this steady-state condition?
d. Would the screw overhaul if a ball thrust bearing (of negligible friction) were used in place of the plain thrust collar.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, hadellolo8839

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, heidiburgos1own6c0

Fluids at rest possess no flow energy. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Do you know the correct answer?

A double-threaded Acme stub screw of known major diameter is used in ajack having a plain thrust col...