Engineering, 16.08.2021 16:30, ineedhelp368
The diameter of the dot produced by a printer is normally distributed with a mean diameter of 0.004 cm and a standard deviation of 0.002 cm. What is the probability that the diameter is between 0.003 and 0.006 cm? (answer to the nearest two decimals)
Answers: 2
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10, xboxdude06
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:20, rjone8429
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
The diameter of the dot produced by a printer is normally distributed with a mean diameter of 0.004...
Mathematics, 10.03.2020 09:01
Mathematics, 10.03.2020 09:02