Engineering, 14.08.2021 07:00, bbby2

Results (When you selected 5V, 9V, 12V in Relay Test software: a) Did the 3 red LEDs light up properly? What
was the power supply output DC voltage for each selected voltage?)
(Add here a photo of this step showing you, computer screen with one of the selections, and your power
supply with the related voltage display)
(If your power supply didn't work as expected, write in your own words what worked and what didn't.)
Hi

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 03:10, lauriepdx17

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

continue

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, yasminothman02

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Do you know the correct answer?

Results (When you selected 5V, 9V, 12V in Relay Test software: a) Did the 3 red LEDs light up prope...