Engineering, 06.08.2021 16:00, rusa25

A cylinder, 6 mm in diameter, has a length of 24 mm. One end of the cylinder is open while all other surfaces have external insulation. The inside of the cylinder is diffuse and gray having an emissivity of 0.8 and a uniform temperature of 1000 K. (a) Draw a sketch and state your assumptions
(b) Determine the radiant power leaving the open end of the cylinder.
(c) Calculate the effective emissivity of the cylinde.
(d) The length of the cylinder is decreased to 6mm, what is the effective emissivity of the cylinder?
(e) If the length of the cylinder is decreased further, do you expect an increase or decrease in the effective emissivity?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, krojas015

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

continue

Engineering, 04.07.2019 19:10, phantomlizz3233

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

continue

Engineering, 04.07.2019 19:10, nani3906

Starting wih an energy balance on a rectangular volume element, derive the one- dimensional transient heat conduction equation for a plane wall with constant thermal conductivity and no heat generation.

Answers: 1

continue

Engineering, 06.07.2019 02:30, khalilh1206

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

continue

Do you know the correct answer?

A cylinder, 6 mm in diameter, has a length of 24 mm. One end of the cylinder is open while all other...