Engineering
Engineering, 03.08.2021 05:30, ashley54899

Question-1 • R1 is 10 k) and R2 is 8 kl. What is the voltage in a pull up resistor (Vout)? Please show the workings for it. (Tip: You may use Tinkercad to attach a multimeter to verify the voltage, Vout) 1 9V Vout 15 pts​

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 18:10, hadellolo8839
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
image
Engineering, 04.07.2019 18:20, 21megoplin
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
Do you know the correct answer?
Question-1 • R1 is 10 k) and R2 is 8 kl. What is the voltage in a pull up resistor (Vout)? Please sh...

Questions in other subjects:

Konu
Arts, 02.09.2020 21:01
Konu
Mathematics, 02.09.2020 21:01
Konu
Mathematics, 02.09.2020 21:01