Engineering, 29.07.2021 01:20, stricklandashley43

The rotating disk is a useful laboratory tool for measuring dissolution of solids. The relationship for the mass transfer coefficient is Sh= 0.62Re^0.5. Se^1/5 where Re= r^2ωrho/μ

where ω is the rotation speed and r is the disk radius. The length parameter in the Sherwood number is the radius. Consider a rotating disk with a 3.0 cm diameter, rotating at 250.0 rpm, with a solid dissolving into a liquid at 25.0°C with the properties of water. The diffusion coefficient of the dissolved solid in water is 2.00x10-9 m²/s, and the solubility of the solid in the liquid is 0.200 kg/m².

Required:
Determine the initial rate of dissolution in kg/s. The initial dissolution rate occurs when there is zero dissolved solid in solution.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:10, oliviasoreo92

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

continue

Engineering, 05.07.2019 23:20, neisha2507

Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket

Answers: 3

continue

Engineering, 06.07.2019 03:10, tyheath42

Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k, p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air

Answers: 1

continue

Do you know the correct answer?

The rotating disk is a useful laboratory tool for measuring dissolution of solids. The relationship...