Engineering
Engineering, 28.07.2021 16:40, biancabahena04

Air in an automobile tire is initially at −10°C and 190 kPa. After the automobile is driven awhile, the temperature gets up to 10°C. Find the new pressure

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 19:20, holaadios222lol
Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.
Answers: 1
image
Engineering, 04.07.2019 19:20, rosemary909
In the winter, in order to keep the classroom steadily at 68 f before 10 pm, heating with an average rate of 42,000 btu/hr is provided. assume the outdoor temperature maintains at 32°f, determine the electrical power (kw) required to (a) operate a reversible heat pump (b) operate a real heat pump with a cop (7) of 4.5 and (c) operate an electrical-resistance heater.
Answers: 3
image
Engineering, 04.07.2019 19:20, mercedesamatap21hx0
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
image
Engineering, 06.07.2019 02:30, josediaz1124
Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.
Answers: 3
Do you know the correct answer?
Air in an automobile tire is initially at −10°C and 190 kPa. After the automobile is driven awhile,...

Questions in other subjects:

Konu
Mathematics, 27.04.2021 01:00
Konu
Mathematics, 27.04.2021 01:00
Konu
Mathematics, 27.04.2021 01:00
Konu
English, 27.04.2021 01:00