Engineering, 22.07.2021 02:00, gonzo8953

2. The condenser and evaporator of a refrigerator with refrigerant-134a as the working fluid work at the constant pressures of 200 psia and 25 psia respectively. The mass flow rate of the refrigerant in the cycle
is 5 lbm/min. The condenser rejects heat to cooling water that enters the condenser at 40°F at a rate of 25.297
lbm/min and leaves at 55°F. The exit of the evaporator (state 1) is saturated vaper but the exit of the condenser
(state 3) is not saturated liquid. The work consumed by the compressor is 23.48 Btu/lbm and the estimated
heat gain of the compressor from the surroundings is 0.81 Btu/lbm. Determine
(a) the enthalpy and temperature at the condenser inlet (h2 and T2)
(b) the enthalpy and temperature at the condenser outlet (h3 and T3)
(c) the refrigeration load in Btu/min
(d) the COP of the refrigerator.
Water
Water
55°F
40°F
Он
Condenser
P= 200 psia
3
2
Qin
Expansion
valve
Win
Compressor
4
Evaporator
P= 25 psia
1
QL

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

Engineering, 04.07.2019 18:20, cdyshaylia55

Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg

Answers: 2

continue

Engineering, 04.07.2019 19:10, moneyyfletcher

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

continue

Do you know the correct answer?

2. The condenser and evaporator of a refrigerator with refrigerant-134a as the working fluid work at...